Speaker Test
Set volume to a comfortable level, then trigger isolated tones.
An acoustic calibration utility built on the Web Audio API. Accurately verify left and right stereo channel separation, detect inverted wiring, test low-frequency bass and high-frequency treble drivers, and run a continuous 20Hz–16,000Hz frequency sweep to expose driver rattle, distortion, and crossover dropouts.
How to Use This Test
- Set your operating system volume to a moderate, safe listening level.
- Click 'Left only' — verify that pure tone emanates exclusively from your left speaker or earbud.
- Click 'Right only' — verify audio emanates strictly from the right side.
- Click 'Bass 80Hz' and 'Treble 8kHz' to evaluate driver frequency limits.
- Click 'Sweep 20Hz→16kHz' to listen for buzzing enclosures, harmonic distortion, or sudden volume dips.
Stereo Imaging & Driver Health Analysis
Stereo sound relies on two discrete audio channels: Channel 1 (Left) and Channel 2 (Right). When audio engineers master music, games, and films, positional cues depend on precise phase alignment and amplitude panning between these channels. If your operating system has 'Mono Audio' enabled in Accessibility settings, both channels are summed into one, completely destroying spatial awareness in gaming and stereo separation in music production.
Frequently Asked Questions
Why does my left speaker play sound when I click 'Right only'?
Your audio hardware is operating in mono mixdown mode, your 3.5mm headphone plug is not fully seated into the jack, or your stereo channel wires are short-circuited inside the cable.
Why is the 80Hz bass tone silent on my laptop speakers?
Small laptop speakers typically have a high-pass acoustic filter that cuts off frequencies below 150Hz–200Hz to prevent physical driver distortion. Real sub-bass reproduction requires larger drivers or headphones.
What does buzzing during the frequency sweep indicate?
A physical rattle during specific frequency ranges indicates acoustic resonance: a loose driver screw, a vibrating plastic grille, or an uncoupled desk surface vibrating with the speaker cabinet.
How do I fix inverted stereo channels (left playing on right)?
For headphones, check the physical 'L' and 'R' markings on the headband. For desktop monitors, verify that the RCA/3.5mm red and white cables are plugged into the corresponding colored ports on your DAC or amplifier.